DEEP-DRAWING PERFORMANCE AND STRUCTURE-PROPERTY RELATIONS OF NIGERIA MILD STEEL

Authors

  • ENO J. IBANGA Department of Physics, University of Agriculture, P.M.B. 2373, Makurdi, Nigeria. Author
  • ANIEDI O. ETTE Department of Mechanical Engineering, University of Agriculture, P.M.B. 2373, Makurdi, Nigeria. Author

Keywords:

Mild Steel, Deep-drawing, Failure, Carbon content, Annealing

Abstract

Most inland rolling mills in Nigeria depend on Delta Steel Company (DSC), Aladja, Nigeria for their billets while the wire drawing companies depend on the rolling mills for their rods. The drawn products therefore owe their final properties to the production history of the billets and the drawing operations. Difficulties encountered by wire drawing companies using locally produced rods in deep drawing operations necessitated metallurgical characterization on the rods. Investigation has revealed that a significant difference exists in the compositional characteristics of the locally produced mild steel rods compared to standard specifications of mild steels for wire drawing applications. The carbon content of the DSC steel is found to be higher than the standard requirements. The ductility was found to be within an acceptable range for mild steel but microstructural analysis revealed decarburization and grain growth during process annealing. Softening of products (wires and nails) was also observed and Brinell hardness number (BHN) was about 56.9% of the standard specification for 0.30% mild steel.

Downloads

Published

1994-12-23