FINITE ELEMENT ANALYSIS OF STRESSES IN A TOOTHED WHEEL

Authors

  • S. A. UGWU MECHANICAL ENGINEERING DEPARTMENT, UNIVERSITY OF NIGERIA, NSUKKA. Author

Abstract

Toothed wheels generally and gears in particular are in constant use in machine operation. Gears under operation, such as in automobile, are subjected to stresses of varying magnitude and dimension.

These stresses set up in a spur gear under operation are analyzed in this paper using Finite Element Method, FEM. The gear models were produced and loaded in a specially built gear loading system to determine the load being transmitted by the wheels.

The dimensions of the wheel were taken and plotted on graph sheet for the purpose of discritization. After the sub-division of the gear tooth into 242 triangular elements (constant strain triangle-CST), each element data namely the elastic properties, coordinates and connectivity of each element and the associated load components, were taken down. Care was taken to refine the mesh at the expected regions of stress concentration.

Then a mainframe computer cyber 932-11 was used to run the programme written and the results dis-played.

Downloads

Published

1995-12-22