PROPERTIES AND MICROSTRUCTURAL EVOLUTION IN HOT ROLLING SIMULATION OF Nb AND C-Mn STEELS
Abstract
Hot simulation has been carried out on the Gleeble 1500 on C-Mn and Nb steels, using 1,2 3 and 5 stage hot compression tests. Test temperatures were varied between 875°C and 1100°C; strain rates between 0.5 and 20s¹; holding times between 0.5 and 30s and strain increments between 0.12 and 0.3 per stage. Metallographic samples were prepared for microstructural evolution measurements.
Maximum stresses obtained varied from 150MPa for Nb steel at 1100°C to 330MPa for C-Mn steel at 875°C.
Effects of variation of Temperature, strain, strain rate, and initial grain size were observed on static, metadynamic and dynamic recrystallisation through measurement of recrystallised grain sizes and observation of shapes of stress-strain curves.
Single peak, non-synchronised stress-strain curves were observed for both C-Mn and Nb steels, after dynamic recrystallisation. Dynamic recrystallisation was also observed to be strain rate and temperature sensitive.
Microstructures of C-Mn steel after static recrystallisation for increasing holding times between passes reveal grain boundary migration, recrystallisation and progressive grain growth characteristics. It was found, however, to be temperature and strain insensitive in contrast to dynamic recrystallisation. Metadynamic recrystallisation reveal strain independence, since strain had exceeded the value of the critical strain. Grain growth behaviour in C-Mn steel was observed metallographically and grain size measurements agreed to a large extent with the parabolic law goveming grain growth behaviour in materials, proposed by Roberts [1]. Microstructural evolution in C-Mn and Nb steels was observed through measurement of austenite grain sizes at the end of each of the same 5 stage compression tests, for both steels., Models proposed by other workers have also been applied to present work and results analysed.