STRAIN-HARDENING CHARACTERISTICS OF NS 34 LC

Authors

  • ENGR. JOHN ADE AJAYI Department of Metallurgical & Material's Engineering, The Federal University of Technology, P. M. B. 704, Akure, Ondo State, Nigeria. Author

Abstract

This paper is based on the research recently carried out on the strain-hardening characteristics of the Nigeria Mild Steel, NS 34 LC, which is used for the manufacturing of nails, barbed wires and office pins among others; the objective is to improve and the drawability of this grade of steel.

The steel is strain-hardened (cold-worked) by wire drawing it at different drafts of 30.56%, 55.56%, 75% and 88.89%. This is followed by sub-critical annealing and metallography. In each case, five mechanical properties tensile strength, yield stress, hardness, per cent reduction in area and per cent elongation -are observed.

For optimum combination of desired mechanical properties on cold-worked NS 34 LC the steel should not be strain-hardened beyond 75% draft and should be critically annealed at 650°C for soaking time of 15 minutes before further deformation.

Downloads

Published

1997-09-30